Blog | Paul Kenneally - Open Source Steadicam | Page 2 of 2

top of page

This site was designed with the

website builder. Create your website today.Start Now

Paul Kenneally - Open Source Steadicam

paul.kenneally1@mycit.ie

Recent Posts

8. My final Outcome (& link to Thingiverse)

8. My final Outcome (& link to Thingiverse)

Build Instructions Part 3 - Putting it all Together

Build Instructions Part 3 - Putting it all Together

7. Finished Building the Steadicam

7. Finished Building the Steadicam

Archive

Tags

3.1 Ordered Parts

3.1 Ordered Parts

I realised that this new project had a lot of potential to be the best designed steadicam yet. And if I was designing new parts for this...

3. Re-designing the Base

3. Re-designing the Base

After ordering the new quick-release plate I realised that if would position the camera way too high in the steadicam and it would make...

2. Designing 3D parts

2. Designing 3D parts

This week I made the part that would connect the handle to the top steadicam at the front and the back. The software that I decided to...

1. Taking Measurements

1. Taking Measurements

The main problem with my last design is that the handles are very unique one-off pieces. If they were not so hard to make I would have...

Project Introduction

Project Introduction

I like to make videos of all styles and types. Short movies, documentaries, music videos, highlight reels and one of my most favorate,...

bottom of page